Learn · Technique · 4 min read
How to use the kerbs: when to ride them and when to stay off
The red and white stripes at the edge of a corner are not decoration. Kerbs mark the edge of the track, protect the grass and the gravel from cars cutting the corner, and give drivers a little extra width to play with. On a fast lap, the car touches a kerb at almost every corner.
But not every kerb is there to be used, and not every kerb can be used the same way. Knowing which ones to attack, which ones to brush and which ones to avoid is part of learning any circuit.
Why kerbs make a corner faster
The racing line is about making a corner as wide as possible, and a kerb adds width. A car that can put two wheels on the inside kerb at the apex can cut the corner by up to a metre. A car that can run out onto the exit kerb can open the curve of its exit by the same amount. A wider curve means a higher speed, and on a corner that leads onto a straight, a higher exit speed carries all the way down it.
So on most corners, the best line uses the kerb on the inside at the apex and the kerb on the outside at the exit. The question is how much of it.
Flat kerbs and sausage kerbs
Kerbs come in different shapes. The most common are low and flat, often with shallow ridges, and a car can drive over them without much fuss. These are the ones drivers use freely at the apex and on the exit.
Behind them, many circuits add taller kerbs, sometimes called sausage kerbs, rounded bumps designed to stop drivers cutting further. Hitting one of these can launch the car, break the suspension or tear off part of the floor. They are not part of the line; they mark where the line ends.
The cost of riding a kerb
Even a flat kerb has a cost. It is bumpier than the track, so the tyres spend part of the time bouncing instead of gripping, and a car that hits a kerb hard while braking or turning can lose grip for a moment. Painted kerbs are also slippery when wet, and many drivers stay off them completely in the rain.
So drivers judge every kerb on its own. A smooth kerb at the apex of a slow corner, where the car is barely loaded, is free time. The same kerb in the middle of a fast corner, where the car is at the limit of its grip, can unsettle it and cost more than it gives back.
Apex kerbs
On the inside of a corner, the kerb lets the car cut a little tighter at the apex. On slow corners, drivers often put the inside wheels well onto it. On fast corners they tend to brush it lightly, enough to use the width but not so much that the car bounces. In chicanes, where the car must change direction quickly, drivers often ride the kerbs hard because cutting across them straightens the path between the two parts.
Exit kerbs
On the outside of the exit, the kerb is a safety margin as much as extra width. A driver who reaches it with the steering already unwinding and the throttle wide open has used every centimetre of the track. A driver who arrives there still turning hard is running out of road, and the next step is the grass.
This is why exit kerbs are where track limits are judged. At most circuits the line at the edge of the track, not the outer edge of the kerb, is the limit. A car with all four wheels beyond it has left the track, and lap times set that way are deleted.
Kerbs and the car
How much a driver can use the kerbs also depends on the car. A car with soft suspension rides over kerbs and keeps its grip, while a stiff car skips across them. Teams sometimes soften the setup at circuits where the kerbs are important, giving up a little performance elsewhere so the drivers can attack them.
Kerbs in Lapdle
In Make the corner, the kerbs are part of the road and the car can use them, but the grass and the gravel beyond are much slower, and the barrier ends the run. The camera shakes as the car crosses a kerb, so you can feel when your line has used the full width of the track and when it has gone further than it should.
The best runs usually touch the inside kerb at the apex and drift out to the outside kerb on the exit, just as a real driver would. Going wider than that costs time, and going narrower leaves speed unused.
Learning the kerbs
When a driver arrives at a new circuit, the kerbs are among the first things they study, on foot and on video. Which ones can be ridden, how high they are, what lies behind them. Then, lap by lap, they use a little more of each, until they find the point where the next centimetre costs more than it gives.
More to learn
- What is a racing line? The fastest way through a corner, explained
- Early, classic or late apex: which is fastest, and when
- How to find the braking point for a corner
- Racing lines in the wet: why the dry line stops working
- Hairpins, chicanes and sweepers: how each type of corner is driven
- Trail braking: how drivers carry the brakes into a corner
- Low downforce: why Monza and Mexico City are driven differently
- Why Monaco is the slowest lap of the year
- How racing drivers learn a new circuit
- Traction: why the exit of a slow corner decides the straight